Adjustments
Angle adjustment
1. Undo the two screws (B) on the underside and adjust the angle to
the required position.
2. Tighten the screws. Tightening torque: 2.1 lb.ft.
Parallel panel holder
The following tools are necessary for this task:
• 1 Torque wrench.
• Allen key, 4 mm.
• Allen key, 5 mm.
Length adjustment
1. Undo the screws on the underside enough to slide the panel holder.
2. Adjust the panel to the required position. Leave at least a gap of 0.4"
between the armrest and the panel.
3. Tighten the screws. Tightening torque: 7.2 lb.ft.
134
Figure 396. Panel holder angles.
Figure 397. The position of the screws on the parallel
panel holder.
Figure 398. Adjusting the position on the parallel panel
holder.
Permobil M1