Permobil M1 Service Manual page 52

Repairs
4. Remove the cover on the top of the swing arm.
5. Unscrew the screw.
6. Remove the spacer, bearing, washer and wheel fork.
Mounting wheel fork
1. Check that the wheel fork and swing arm with bearings and friction
brake are not damaged. Clean to remove dirt and rust. Replace
damaged parts. Make sure the washer is mounted on the wheel fork.
2. Fit the wheel fork together with the washer, bearing and spacer on
the swing arm using just your hands. Check that the wheel fork is
fully pushed into the swing arm.
3. Fit the screw. Screw the friction brake in place while holding the
wheel fork. Tightening torque: 17.7 lb.ft
52
Figure 139. Remove the cover and unscrew the screw.
Figure 140. The spacer, bearing, washer and wheel
fork.
Figure 141. The spacer, bearing, washer and wheel
fork.
Figure 142. Push the cover into place.
Permobil M1