Permobil M1 Service Manual page 109

Permobil M1
5. Loosen the two screws that are mounted by the key holes.
6. Remove the other six screws.
7. Lift of the lower part of the seat tilt from the chassis.
Install seat tilt, lower part
1. Hang the lower part of the seat tilt on the chassis.
2. Tighten the two screws on the key holes. Allen key 6 mm.
Tightening torque: 17,7 lb.ft.
3. Attach the other six screws to the seat. Allen key 6 mm. Tightening
torque: 17,7 lb.ft.
4. Attach two screws on the plate that holds electronics. Allen key
4 mm. Tightening torque: 4,2 lb.ft.
Figure 330. Remove eight screws to loosen the lower
part of the seat tilt.
Figure 331. Attach eight screws to the seat.
Figure 332. Attach two screws to the plate that holds
electronics.
Repairs
109