Permobil M1 Service Manual page 69

Permobil M1
Mounting VR2 control panel
1. Assemble the control panel. It is held in place by two screws.
Tightening torque: 2.2 lb.ft.
2. Attach the control panel cabling in the cable clips running through
the armrest pad.
3. Attach the control panel cabling in the cable clips on the inside of
the armrest arm.
4. Attach the control panel cabling in the cable clip on the outside of
the armrest arm. Bend the cable around the armrest joint.
Figure 203. The control panel with the standard panel
holder is held in place by two screws and two washers
on the panel holder.
Figure 204. The position of the cable clips under the
armrest pad.
Figure 205. The position of the cable clips on the inside
of the armrest arm.
Figure 206. The position of the cable clip on the outside
of the armrest arm.
Repairs
69