Permobil M1 Service Manual page 71

Permobil M1
10. Attach the control panel cable into the cable holders.
11. Connect the control panel cable connector to the JSM connection
on the power module.
1. Switch On the main power switch on the control panel.
2. Switch the main circuit breaker to On. See
Main circuit breaker , Page 79.
3. Mount back the chassis covers, see Covers , Page 14.
R–net control panel
The following tools are necessary for this task:
• 1 Allen key 4 mm.
Removing R–net control panel
1. Switch Off the main power switch on the control panel.
2. Switch the main circuit breaker to Off. See
Main circuit breaker , Page 79.
3. Remove the chassis covers, see Covers , Page 14.
4. Remove the control panel cabling from the cable clips running
through the armrest pad.
Figure 211. The position of the cable running in the
cable holders on the battery box.
Figure 212. On/Off symbol depending on model.
Figure 213. On/Off symbol depending on model.
Figure 214. The position of the cable clips under the
armrest pad.
Repairs
71