Permobil M1 Service Manual page 117

Permobil M1
12. Place the support rod in position corresponding to the seat to floor
height choosen.
13. Fit the pin.
14. Fit the shim washer and the the circlip, ensure that it locks in the
groove.
15. Tighten the M12 bolt (C). Tightening torque: 84.1lb.ft
16. Extend or shorten the cable loop with approximately the length
added or removed by seat height change.
17. Run the seat tilt in full angel to make sure the cable loop is enough.
18. Mount covers, see Covers .
19. Mount seat plate, see Remove seat plates , Page 96.
20. Mount cushions.
Fixed seat height
1. Remove cushions.
2. Remove seat plates, (remember where they were mounted).
1. Loosen the M12 bolt from position (A).
2. Fit the M12 bolt into service mode position, the threaded hole (B).
3. Screw the M12 bolt downwards to raise the seat and allow access to
the bracket (C).
4. Move bracket (C) to its new position.
5. Fit the M8 screws (D), tighten them using a torque wrench.
Tightening torque: 17.7 lb.ft.
6. Move M12 screw back to original position (A).
7. Fasten the M12 screw . Tightening torque: 84.1lb.ft.
8. Mount seat plates, see Remove seat plates , Page 96.
9. Mount cushions.
Figure 347. Support rod positions.
Figure 348. Tilt seat fixed height adjustments. The seat
is made invisible, the image only shows details affected
by the adjustment.
Figure 349. Fixed seat height adjustment. The seat is
made invisible, the image only shows details affected
by the adjustment.
Adjustments
117