Permobil M1 Service Manual page 32

Repairs
1. Use the battery straps and lift the new batteries in reverse order
(leave the straps on the new batteries).
2. Make sure the batteries are positioned correctly to bring their
terminals into the right position; refer to the wiring diagram.
Connect the four wires to the correct terminals on the batteries as
shown in the diagram.
3. Tighten the screws. Tightening torque 4.2 lb.ft.
4. Slide up the battery terminal covers.
CAUTION!
Replace damaged or missing terminal covers
Always replace damaged or missing terminal covers to avoid short circuit.
5. Push the battery box into the chassis.
6. Check your documentation of the cable setup ...
32
Figure 75. The wiring diagram for battery connection.
Figure 76. Slide up the covers.
Figure 77. Push in the battery box.
Figure 78. Check your documentation of the cable
setup.
Permobil M1