Permobil M1 Service Manual page 103

Permobil M1
1. Remove the seat cushion by lifting it straight up. It is attached with
Velcro tape on the bottom side of the cushion.
2. Remove the seat plates. See Remove seat plates , Page 96
3. Record the screw positions.
4. Remove the rear screws (B, D).
5. Remove the front screws (A, C).
6. Lift off the leg rest straight out.
7. Put the leg rest on a flat surface.
Use a protection mat to prevent damage to the seat and the surface it is
put on.
Install leg rest
WARNING!
Risk of injury while adjusting leg rest
Do not place any weight or load on the leg rest while adjusting the leg rest.
1. Secure that screw (B) is in the proper position as indicated by the
scale, see Seat matrix page 118. Fit the screws (A, B),washers and
tighten them using a torque wrench. Tightening torque: 17.7 lb.ft
It is important that screws (A) and (B) are secured first, as they have only
unique positions that fit. Screw (D) have overlapping positions possible
that may lead to misalignment if secured before (A) and (B).
2. Fit the screws (C, D), washers and tighten them using a torque
wrench. Tightening torque: 17.7 lb.ft.
3. Attach the seat plates. See Install seat plates , Page 96
4. Attach the seat cushion by pushing it against the seat plate. Make
sure that the Velcro tape on the bottom side of the cushion is
attached to the seat.
Figure 313. It is important that you document the screw
positions. Take a photography or draw it.
Figure 314. Removing the leg rest.
Figure 315. Mounting leg rest.
Repairs
103