Permobil M1 Service Manual page 95

Permobil M1
3. Attach the pin into the armrest lock.
4. Mount the armrest arm together with the slide bearing and washer.
On the washer there is a Teflon side; that side must face the hinge.
5. Attach the screw to secure the bushing and the two washers. On
one of the washers there is a Teflon side; that side must face the
bushing. Tightening torque: 17.7 lb.ft.
6. Attach the screw and washer from the inside of the armrest lock into
the armrest holder. Tightening torque: 4.2 lb.ft.
Seat frame
The following tools are necessary for this task:
• Torque wrench.
• Allen socket, 3 mm.
• Allen socket, 4 mm.
• Allen socket, 5 mm.
• Socket, 10 mm.
• Means of documentation (camera, pen and paper etc.).
Figure 291. The inner parts of the armrest joint.
Figure 292. The outer parts of the armrest joint.
Figure 293. The inside of the armrest lock.
Repairs
95