Control Panel And Electronics - Permobil M1 Service Manual

Permobil M1
6. Apply a thin layer of Loctite 638 around the chamfer of the shaft.
7. Fit the screw (TUF-LOK) with washers on the axle. Mind the
assembly order of the different types of washer. Push the hub onto
the axle by tightening the screw. Tighten the screw using a torque
wrench. Tightening torque: 24.3 lb.ft.
WARNING!
Replace wheel hub screw
Failure to follow these instructions could cause the wheel to malfunction
causing damage to the wheelchair and/or bodily injury.

Control panel and electronics

ISM and ESP
If the wheelchair is fitted with R-net electronics it will be equipped
with an ISM (Intelligent Seating Module) and optionally an ESP
(Enhanced Steering Performance).
Preparation ISM/ESP
1. Switch Off the main power switch on the control panel.
2. Switch the main circuit breaker to Off. See
Main circuit breaker , Page 79.
3. Remove the front cover and the top cover, see
Removing chassis covers , Page 14.
Figure 172. Apply a thin layer of Loctite 638 around
the chamfer of the shaft.
Figure 173. Mind the assembly order of the different
type of washers.
Figure 174. On/Off symbol depending on model.
Repairs
61