Power Module - Permobil M300 Service Manual

Power Module

Power Module R-net
Removal
1. Switch off the main power switch on the
control panel.
2. Switch the main fuse to OFF. See page 50.
3. Remove the chassis covers. See page 8-9.
4. Remove the electronics by gently pulling/
spreading the locking handles to disengage
the locking tabs on the left and right hand
side of the chassis (see fig.).
Remove the electronics by gently pulling the locking handles on the
left and right side of the chassis outwards and disengaging the tabs.
5. Disconnect the electrical connections from the Power Module. Note their positions (see fig. below).
Motor 1
Left
For this task the following tools are necessary:
1
Motor 2
Battery
Power Module cable connections
44
Wrench 8 mm.
Right
Inhibit
External
charging socket