Permobil M1 Service Manual page 35

Permobil M1
13. Switch the automatic main circuit breaker to the On position and
switch on the power supply using the on/off key on the control
panel.
14. Test the chair for proper operation.
Cable holder – battery box
Removing cable holder – battery box
1. Switch Off the main power switch on the control panel.
2. Switch the main circuit breaker to Off. See
Main circuit breaker , Page 79.
3. Remove the chassis covers, see Covers , Page 14.
4. Pull out the cables attached into the cable holder.
5. Push the cables to the side.
ON / OFF
Figure 86. Main circuit breaker is located under the
Permobil logotype on the rear cover.
Figure 87. On/Off symbol depending on model.
Figure 88. On/Off symbol depending on model.
Figure 89. The cables runs through the cable holders.
They are located on each side of the power module.
Repairs
35