Permobil M1 Service Manual page 46

Repairs
9. Raise the front swing arm (C) and mount the rear swing arm to the
FlexLink™. It is fitted with one screw (A) and a washer (B).
10. Mount the fenders. See Covers , Page 14.
11. Mount the drive wheel. See Drive wheels , Page 37.
Removing front swing arm
1. Remove the drive wheel. See Drive wheels , Page 37.
2. Remove the rear chassis cover and the fender. See Covers , Page 14.
3. Disconnect the motor cables from the power module.
4. Remove the cable from the cable tunnel (A).
5. Remove the screw from the bracket holding the cable clips (B).
Leave the cable clip on so that the clip is maintained at correct place
on the cable.
6. Remove the FlexLink™. See Shock absorbers , Page 53.
7. Remove the drive unit. See Drive units , Page 54.
8. Remove the cover (D) from the swing arm by pulling it straight out.
If necessary, carefully lever it out using a screwdriver in the slot on
the cap.
9. Remove the swing arm (A), it's fitted with a screw (C) and a washer
(B).
46
Figure 116. FlexLink™ screw assembly.
Figure 117. Magnetic wheel lock connection and drive
motor connection on power module.
A
B
Figure 118. Cabling drive unit.
A
B
C
D
Figure 119. Front swing arm removal.
Permobil M1