Table of Contents
Advertisement
ADAPTING
TO LOCAL
POWER
SOURCE
The SQD-2020 operates on either 110V, 127V, 220V or 240V ac.
Before operating, check
whether
or not
the
SQD-2020
is set
for the same
voltage as your local power
source.
The voltage
selector can
be reset as follows:
1. Disconnect ac power
cord before
proceeding.
2. Loosen
the two screws on the voitage selector cover (but do
not remove
the arrow-marked
screw from the cabinet).
3. Move the cover aside so that you can
unplug the selector.
4. Pull out the selector and reinsert it so that the arrow on the
plug points to the proper voltage
marking.
5. After changing
voltage, replace the cover.
DO AND
DON'T'S
No doubt you have already decided
on a location for your SQD-
2020.
However, before going ahead with the installation,
make
sure that your choice of location
agrees
with the following
list
of DO
and DON'T's.
DO
allow sufficient room behind the SQD-2020 so you.--1
make connections to the rear
panel
without
disrup.
J
your entire setup.
DON'T
place the SQD-2020
in direct sunlight, or near radiators,
hot-air
ducts,
or
any
other
source
of heat.
Similarly,
don't place it in any areas subject to freezing tempera-
tures or excessive moisture.
DON'T connect the SQD-2020 to any voltage other than that
indicated by the voltage selector.
DON'T make connections with power turned on.
SYSTEM
CONNECTIONS
The owner of a good quality two-channel
system*
can
convert
to a four-channe!
system
by adding the Sony SQD-2020,
a back
power
amplifier and two
more
loudspeakers.
* Stereo system must have a tape/source monitor selector.
Use
the existing connections
between
phono, fm/a-m
tuner or
auxiliary
sources
and
the front
amplifier.
But
reconnect
the
two-channe}
tape
recorder
to the
SQD-2020.
Refer
to the
illustration
on pages
8 and
9.
For best four-channe! reproduction, use amplifiers with thes.
+
power-rating and speakers with the same
characteristics for the
front and back channels.
However, even if the front and back
speakers (or amplifiers) are different, you will get good
results
after adjusting channal
levels as directed
on pages
18-31.
Advertisement
Table of Contents
