System Frequency Settings; Input Video Selection; Input Video Upconvert Settings; Output Video Format Settings - Sony NU-IP40D Instructions For Use Manual

System Frequency Settings

Configure the system frequency for network video
transmissions. The sender side must be configured
according to the video format of the video output device.
DIP switch 1
System frequency
[6]
OFF 59.94 Hz/60 Hz
ON 50 Hz
1) When 59.94 Hz/60 Hz is selected, 60 Hz video is converted to
59.94 Hz and transmitted.
Note
Video cannot be transmitted properly if the system
frequency and frame frequency of the input video do not
match. Be sure to adjust the video frequency settings on
the video output device.

Input Video Selection

DIP switch 1
Input video
[3] [4] [5]
OFF DVI-D
OFF
OFF ON HDMI
ON OFF Analog RGB (HD15)
OFF Component (RGB)
OFF
ON Component (YCbCr)
ON
OFF VIDEO
ON
ON S VIDEO
1) Attach the supplied NUA-AA10 analog adapter.
2) Attach the supplied NUA-AA10 analog adapter and the
SMF-405 signal cable (not supplied).

Input Video Upconvert Settings

When the input video resolution is less than 1920×1080,
convert the video resolution to 1920×1080 before
transmission.
Two methods of resolution conversion are available,
expanded mode and dot-by-dot mode.
In expanded mode, the resolution is expanded while
retaining the aspect ratio.
In dot-by-dot mode, a black border is inserted around
the input video, converting the image as a whole to
1920×1080.
DIP switch 3
Upconvert mode
[4]
OFF Expanded mode
ON Dot-by-dot mode
1)
1)
2)
2)
2)
2)

Output Video Format Settings

Configure the output video format according to the
transmission video format.
For details on the relationship between the input video
format and the transmission video format, see page 31.
DIP switch 1
Transmission video format/output
video format
[3] [4] [5]
OFF 1920×1080/50i
OFF
ON 1920×1080/59.94i
OFF
OFF 1920×1080/50p
ON
ON 1920×1080/59.94p
OFF 3840×2160/50p
OFF
ON 3840×2160/59.94p
ON
OFF 4096×2160/50p
ON
ON 4096×2160/59.94p
1) 1920×1080/50i Level B-DS formats transmitted from the
NU-IP40S are output as 1920×1080/50p from the NU-
IP40D.
2) 1920×1080/59.94i Level B-DS formats transmitted from the
NU-IP40S are output as 1920×1080/59.94p from the NU-
IP40D.
Note
If the connected monitor does support the above
formats, output at VGA resolution (640×480).
For details on configuring this setting, see "VGA output
setting (DIP switch 1 [7])" under "DIP Switch Settings"
(page 36).
Output Video 3G-SDI Level B Support
Settings
Configure according to the video format sent from the
NU-IP40S.
DIP switch 1
3G-SDI Level B Support
[6]
OFF Other than below
ON Video format from the NU-IP40S is 3G-
SDI Level B DS

Output Video Color Space Settings

Configure the color space for the output video.
The configuration is fixed at YCbCr for the 4K video
format.
DIP switch 3
Color space
[5]
OFF RGB
ON YCbCr
19
1)
2)
1)
2)