Network Filter Configuration
518
G8332 Command Reference for ENOS 8.4
The following table describes the Network Filter commands.
Table 269.
IP Network Filter Configuration Options
Command Syntax and Usage
ip matchaddress <1‐256> <IP address> <IP netmask>
Sets the starting IP address and IP Netmask for this filter to define the range of
IP addresses that will be accepted by the peer when the filter is enabled.
The default address is 0.0.0.0 0.0.0.0.
Command mode: Global configuration.
[no] ip matchaddress <1‐256> enable
Enables or disables the Network Filter configuration.
Command mode: Global configuration
no ip matchaddress <1‐256>
Deletes the Network Filter configuration.
Command mode: Global configuration
show ip matchaddress [<1‐256>]
Displays the current the Network Filter configuration.
Command mode: All