Rip Interface Configuration - Lenovo RackSwitch G8332 Command Reference Manual

RIP Interface Configuration

© Copyright Lenovo 2016
The RIP Interface commands are used for configuring Routing Information
Protocol parameters for the selected interface.
Note: Do not configure RIP version 1 parameters if your routing equipment uses
RIP version 2.
Table 275.
RIP Interface Options
Command Syntax and Usage
ip rip authentication key <password>
Configures the authentication key password.
Command mode: Interface IP
no ip rip authentication key
Removes the authentication key password.
Command mode: Interface IP
ip rip authentication type password <password>
Configures the authentication type.
The default is none.
Command mode: Interface IP
no ip rip authentication type
Removes the authentication type.
Command mode: Interface IP
ip rip default­action {listen|supply|both}
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways.
The default value is none.
Command mode: Interface IP
no ip rip default­action
Configures the switch to reject RIP default routes.
Command mode: Interface IP
[no] ip rip enable
Enables or disables RIP on the current interface.
Command mode: Interface IP
[no] ip rip listen
When enabled, the switch learns routes from other routers.
The default value is enabled.
Command mode: Interface IP
Chapter 4: Configuration Commands
527