Ipv4 Filtering Configuration - Lenovo RackSwitch G8332 Command Reference Manual

IPv4 Filtering Configuration

420
G8332 Command Reference for ENOS 8.4
These commands allow you to define IPv4 matching criteria for an ACL.
Table 195.
IP version 4 Filtering Configuration Options
Command Syntax and Usage
access­control list <1‐256> ipv4 destination­ip­address
<IP address> [<IP mask>]
Defines a destination IP address for the ACL. If defined, traffic with this
destination IP address will match this ACL.
Command mode: Global configuration
no access­control list <1‐256> ipv4 destination­ip­address
Deletes the configured destination IP address for the specified ACL.
Command mode: Global configuration
access­control list <1‐256> ipv4 protocol <0‐255>
Defines an IP protocol for the ACL. If defined, traffic from the specified
protocol matches this filter. Specify the protocol number. Listed below are
some of the well‐known protocols.
Number Name
1 icmp
2 igmp
6 tcp
17 udp
89 ospf
112 vrrp
Command mode: Global configuration
no access­control list <1‐256> ipv4 protocol
Deletes the configured IP protocol for the specified ACL.
Command mode: Global configuration
access­control list <1‐256> ipv4 source­ip­address
<IP address> [<IP mask>]
Defines a source IP address for the ACL. If defined, traffic with this source IP
address will match this ACL. Specify an IP address in dotted decimal notation.
Command mode: Global configuration
no access­control list <1‐256> ipv4 source­ip­address
Deletes the configured source IP address for the specified ACL.
Command mode: Global configuration
access­control list <1‐256> ipv4 type­of­service <0‐255>
Defines a Type of Service (ToS) value for the ACL. For more information on
ToS, refer to RFC 1340 and 1349.
Command mode: Global configuration