398
G8332 Command Reference for ENOS 8.4
Table 177.
Port Configuration Options (continued)
Command Syntax and Usage
[no] reflectiverelay force
Enables or disables constraint to always keep reflective relay active.
The default setting is disabled.
Command mode: Interface port
[no] rmon
Enables or disables Remote Monitoring (RMON) on the current port.
Command mode: Interface port/Interface portchannel
shutdown
Disables the port. (To temporarily disable a port without changing its
configuration attributes, refer to "Temporarily Disabling a Port" on page
Command mode: Interface port/Interface portchannel
no shutdown
Enables the port.
Command mode: Interface port/Interface portchannel
stormcontrol {broadcast|multicast|unicast} level rate
<0‐2097151>
Limits the available bandwidth for broadcast, multicast or unicast messages to
the specified value.
Command mode: Interface port/Interface portchannel
no stormcontrol {broadcast|multicast|unicast}
Sets the port to forward all broadcast, multicast or unicast packets.
Command mode: Interface port/Interface portchannel
[no] switchport
Enables or disables routing on a port.
Command mode: Interface port/Interface portchannel
switchport access vlan <VLAN ID (1‐4094)>
Configures the associated VLAN used in access mode. Default value is 1 for
data ports and 4095 for the management port.
Command mode: Interface port/Interface portchannel
no switchport access vlan
Resets the access VLAN to its default value.
Command mode: Interface port/Interface portchannel
404.)