Ip Access List Configuration - Lenovo RackSwitch G8332 Command Reference Manual

IP Access List Configuration

522
G8332 Command Reference for ENOS 8.4
Use the following commands to configure an access list statement on the current
route‐map.
Note: The access list number (1‐32) represents the IP access list you wish to
configure.
Table 271.
IP Access List Configuration Options
Command Syntax and Usage
access­list <1‐32> action {permit|deny}
Permits or denies action for the access list.
Command mode: Route map
[no] access­list <1‐32> enable
Enables or disables the access list.
Command mode: Route map
[no] access­list <1‐32> match­access­control <1‐256>
Sets the network filter number.
Command mode: Route map
[no] access­list <1‐32> match­address <1‐256>
Sets the network filter number. See "Network Filter Configuration" on
page 518 for details.
Command mode: Route map
access­list <1‐32> metric <1‐4294967294>
Sets the metric value in the AS‐External (ASE) LSA.
Command mode: Route map
no access­list <1‐32> metric
Removes the current metric value for the specified access list.
Command mode: Route map
no access­list <1‐32>
Deletes the access list.
Command mode: Route map
show route­map <1‐255> access­list <1‐32>
Displays the current Access List configuration.
Command mode: All