Vmready Configuration; Vm Policy Bandwidth Management - Lenovo RackSwitch G8332 Command Reference Manual

VMReady Configuration

VM Policy Bandwidth Management

© Copyright Lenovo 2016
The following table describes the VMReady configuration options.
Table 363.
VMReady Configuration Options
Command Syntax and Usage
[no] virt enable
Enables or disables VMReady. Before you enable VMReady, you must define
one or more server ports. See "Server Port Configuration" on page
Note: The no form of this command deletes all configured VM groups.
Command mode: Global configuration
show virt
Displays the current virtualization parameters.
Command mode: All
The following table describes the bandwidth management options for the selected
VM. Use these commands to limit the bandwidth used by each VM.
Table 364.
VM Bandwidth Management Options
Command Syntax and Usage
[no] virt vmpolicy vmbwidth {<MAC address>|<UUID>|<name>|
|<IP address>|<index number>} bwctrl
Enables or disables bandwidth control on the VM policy.
Command mode: Global configuration
virt vmpolicy vmbwidth {<MAC address>|<UUID>|<name>|
|<IP address>|<index number>} rxrate <0‐40000000> <max. burst (0‐4096)>
The first value configures Committed Rate—the amount of bandwidth
available to traffic transmitted from the switch to the VM, in kilobits per
second. Enter the value in multiples of 64.
The second values configures the maximum burst size, in kilobits. Enter one of
the following values: 0, 32, 64, 128, 256, 512, 1024, 2048 or 4096.
Command mode: Global configuration
Chapter 4: Configuration Commands
395.
637