Radius Server Configuration - Lenovo RackSwitch G8332 Command Reference Manual

RADIUS Server Configuration

352
G8332 Command Reference for ENOS 8.4
The following table describes the RADIUS Server commands.
Table 151.
RADIUS Server Configuration Options
Command Syntax and Usage
[no] radius­server backdoor
Enables or disables the RADIUS backdoor for Telnet/SSH/HTTP/HTTPS. The
default value is disabled.
To obtain the RADIUS backdoor password for your switch, contact your
Service and Support line.
Command mode: Global configuration
[no] radius­server enable
Enables or disables the RADIUS server.
Command mode: Global configuration
radius­server port <UDP port number (1500‐3000)>
Configures the RADIUS server port. Enter the number of the UDP port to be
configured.
The default port is 1645.
Command mode: Global configuration
default radius­server port
Resets the RADIUS server port to the default UDP port ‐ 1645.
Command mode: Global configuration
radius­server primary­host {<hostname>|<IP address>} key
<1‐32 characters>
Sets the primary RADIUS server address and the shared secret between the
switch and the RADIUS server(s).
Command mode: Global configuration
radius­server primary­host {data­port|mgt­port}
Defines the primary interface port to use to send RADIUS server requests.
Select the port to use for data transfer.
Command mode: Global configuration
no radius­server primary­host [key]
Deletes the primary RADIUS server. The key option only deletes the shared
secret between the switch and the RADIUS server.
Command mode: Global configuration
radius­server retransmit <1‐3>
Sets the number of failed authentication requests before switching to a
different RADIUS server.
The default is 3 requests.
Command mode: Global configuration