Ospf Virtual Link Configuration - Lenovo RackSwitch G8332 Command Reference Manual

OSPF Virtual Link Configuration

536
G8332 Command Reference for ENOS 8.4
The following table describes the OSPF Virtual Link commands.
Table 281.
OSPF Virtual Link Configuration Options
Command Syntax and Usage
area­virtual­link <1‐3> area <0‐19>
Configures the OSPF area index for the virtual link.
Command mode: Router OSPF
area­virtual­link <1‐3> dead­interval <1‐65535>
area­virtual­link <1‐3> dead­interval <1000‐65535 ms>
Configures the health parameters of a hello packet, in seconds or milliseconds.
The default value is 40 seconds.
Command mode: Router OSPF
[no] area­virtual­link <1‐3> enable
Enables or disables OSPF virtual link.
Command mode: Router OSPF
area­virtual­link <1‐3> hello­interval <1‐65535>
area­virtual­link <1‐3> hello­interval <50‐65535 ms>
Configures the authentication parameters of a hello packet, in seconds or
milliseconds.
The default value is 10 seconds.
Command mode: Router OSPF
area­virtual­link <1‐3> key <password>
Configures the password (up to eight characters) for each virtual link.
The default setting is none.
Command mode: Router OSPF
no area­virtual­link <1‐3> key
Removes the authentification key.
Command mode: Router OSPF
area­virtual­link <1‐3> message­digest­key <1‐255>
Sets MD5 key ID for each virtual link.
The default setting is none.
Command mode: Router OSPF
no area­virtual­link <1‐3> message­digest­key
Removes the MD5 key ID for the specified virtual link.
Command mode: Router OSPF