Initial Configuration; Logging In To The Switch - Lenovo Flex System EN2092 User Manual

1. Start a Web browser. The Web-browser window opens.
2. In the URL field, enter the IP address of the switch, in the following format:
3. Enter the switch user ID and password and click OK. The default user ID is
Note: The passwords that are used to access the switch are case-sensitive. To

Initial configuration

The operating firmware on the switch contains default configuration files that are
installed during the firmware installation. These initial configuration settings are
not in a separate configuration file but are components of the firmware. When you
restore the management module to factory defaults, the original configuration is
restored. For more information about configuring and managing the switch
through the management module, see the Command Reference for the switch.

Logging in to the switch

The switch supports user-based security that enables you to prevent unauthorized
users from accessing the switch or changing its settings.
To log in to the switch, complete the following steps:
1. At the prompt, type your user ID and press Enter. The default user ID is
2. Type your password and press Enter. The default password is PASSW0RD. The
After you log on to the switch, you must set the date and time. See the Command
Reference for the switch to perform this task and others as needed.
22
1Gb Ethernet Scalable Switch: User's Guide
http://xxx.xxx.xxx.xxx. The login window opens.
USERID. The default password is PASSW0RD. The password is spelled with a zero,
not the letter O.
increase system security, change the password after you log on for the first
time.
USERID.
password is spelled with a zero, not the letter O. The main-menu window
opens.