vLAG Health Check Configuration
© Copyright Lenovo 2016
These commands enable you to configure a way to check the health status of the
vLAG peer.
Table 241.
vLAG Health Check Configuration Options
Command Syntax and Usage
vlag hlthchk connectretryinterval <1‐300>
Sets, in seconds, the vLAG health check connect retry interval.
The default value is 30 seconds.
Command mode: Global configuration
no vlag hlthchk connectretryinterval
Resets the vLAG health check connect retry interval to its default value of 30
seconds.
Command mode: Global configuration
vlag hlthchk keepaliveattempts <1‐24>
Sets the number of vLAG keep alive attempts.
The default value is 3.
Command mode: Global configuration
no vlag hlthchk keepaliveattempts
Resets the number of vLAG keep alive attempts to the default value of 3.
Command mode: Global configuration
vlag hlthchk keepaliveinterval <2‐300>
Sets, in seconds, the time between vLAG keep alive attempts.
The default value is 5 seconds.
Command mode: Global configuration
no vlag hlthchk keepaliveinterval
Resets the time between vLAG keep alive attempts to the default value of 5
seconds.
Command mode: Global configuration
vlag hlthchk peerip {<IPv4 address>|<IPv6 address>}
Configures the IP address of the peer switch, used for health checks. Use the
management IP address of the peer switch. For example:
IPv4 address: 100.20.0.103
IPv6 address: 3001:0:0:0:0:0:abcd:1234
Command mode: Global configuration
no vlag hlthchk peerip
Deletes the IP address of the peer switch, used for health checks.
Command mode: Global configuration
Chapter 4: Configuration Commands
481