Operations-Level VRRP Commands
© Copyright Lenovo 2016
VRRP operation commands are listed in the following table.
Table 387.
Virtual Router Redundancy Operations
Command Syntax and Usage
router vrrp backup group
Forces the specified master virtual router on this switch into backup mode.
This is generally used for passing master control back to a preferred switch
once the preferred switch has been returned to service after a failure. When
this command is executed, the current master gives up control and initiates a
new election by temporarily advertising its own priority level as 0 (lowest).
After the new election, the virtual router forced into backup mode by this
command will resume master control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router
and its IP interface are the same).
This switch's virtual router has a higher priority and preemption is enabled.
There are no other virtual routers available to take master control.
Command Mode: Privileged EXEC
Chapter 5: Operations Commands
679