Lenovo RackSwitch G8332 Command Reference Manual page 480

480
G8332 Command Reference for ENOS 8.4
Table 240.
vLAG Configuration Options
Command Syntax and Usage
[no] vlag portchannel <1‐104> enable
Enables or disables vLAG on the selected LAG.
Command mode: Global configuration
vlag priority <0‐65535>
Configures the vLAG priority for the switch, used for election of Primary and
Secondary vLAG switches. The switch with lower priority is elected to the role
of Primary vLAG switch.
Command mode: Global configuration
no vlag priority
Resets the vLAG priority of the switch to its default value of 0.
Command mode: Global configuration
vlag startup­delay <0‐3600>
Sets, in seconds, the vLAG startup delay interval.
The default value is 120 seconds.
Command mode: Global configuration
no vlag startup­delay
Sets the vLAG startup‐delay timer to the default 120 seconds duration.
Command mode: Global configuration
vlag tier­id <1‐512>
Sets the vLAG peer ID.
Command mode: Global configuration
no vlag tier­id
Resets the vLAG peer ID to its default value of 0.
Command mode: Global configuration
[no] vlag vrrp active
Enables or disables vLAG VRRP active mode.
Note: If active mode is disabled, the switch will be in passive mode.
In active mode, Layer 3 traffic is forwarded in all vLAG related VRRP
domains.
In passive mode, Layer 3 traffic is forwarded in a vLAG related VRRP
domain only if either the switch or its peer virtual router is the VRRP master.
Command mode: Global configuration
show vlag
Displays current vLAG parameters.
Command mode: All