Igmp Querier Configuration - Lenovo RackSwitch G8332 Command Reference Manual

IGMP Querier Configuration

© Copyright Lenovo 2016
Table 313.
IGMP Advanced Configuration Options (continued)
Command Syntax and Usage
ip igmp timeout <1‐255>
Configures the timeout value for IGMP Membership Reports (host). Once the
timeout value is reached, the switch removes the host from its IGMP table, if
the conditions are met.
The range is from 1 to 255 seconds. The default is 10 seconds.
Command mode: Global configuration
no ip igmp timeout
Resets the timeout value for IGMP Membership Reports (host) to its default
value of 10 seconds.
Command mode: Global configuration
The following table describes the commands used to configure IGMP Querier.
Table 314.
IGMP Querier Configuration Options
Command Syntax and Usage
[no] ip igmp querier enable
Enables or disables IGMP Querier.
Command mode: Global configuration
[no] ip igmp querier port <port alias or number>
Adds or removes the specified port to/from IGMP Querier.
Command mode: Global configuration
ip igmp querier vlan <VLAN ID (1‐4094)> election­type
{ipv4|mac}
Sets the IGMP Querier election criteria as IP address or Mac address.
The default setting is ipv4.
Command mode: Global configuration
no ip igmp querier vlan <VLAN ID (1‐4094)> election­type
Resets the IGMP Querier election criteria to its default value ‐ ipv4.
Command mode: Global configuration
[no] ip igmp querier vlan <VLAN ID (1‐4094)> enable
Enables or disables IGMP Querier for the selected VLANs.
Command mode: Global configuration
Chapter 4: Configuration Commands
581