Igmp Relay Multicast Router Configuration - Lenovo RackSwitch G8332 Command Reference Manual

IGMP Relay Multicast Router Configuration

576
G8332 Command Reference for ENOS 8.4
The following table describes the commands used to configure multicast routers
for IGMP Relay.
Table 308.
IGMP Relay Mrouter Configuration Options
Command Syntax and Usage
ip igmp relay mrouter <1‐2> address <IP address>
Configures the IP address of the IGMP multicast router used for IGMP Relay.
Command mode: Global configuration
ip igmp relay mrouter <1‐2> attempt <1‐128>
Configures the number of successful ping attempts required before the switch
declares this Mrouter is up.
The default value is 5.
Command mode: Global configuration
[no] ip igmp relay mrouter <1‐2> enable
Enables or disables the multicast router.
Command mode: Global configuration
ip igmp relay mrouter <1‐2> interval <1‐60>
Configures the time interval between ping attempts to the upstream Mrouters,
in seconds.
The default value is 2.
Command mode: Global configuration
ip igmp relay mrouter <1‐2> retry <1‐120>
Configures the number of failed ping attempts required before the switch
declares this Mrouter is down.
The default value is 4.
Command mode: Global configuration
ip igmp relay mrouter <1‐2> version <1‐2>
Configures the IGMP version (1 or 2) of the multicast router.
Command mode: Global configuration
no ip igmp relay mrouter <1‐2>
Deletes the multicast router from IGMP Relay.
Command mode: Global configuration
show ip igmp relay
Displays the current IGMP Relay configuration.
Command mode: All