NAT Information
NAT Status Information
148
G8332 Command Reference for ENOS 8.4
The following commands display information about Network Address Translation
(NAT) settings.
Table 67.
NAT Information Options
Command Syntax and Usage
show ip nat
Displays NAT status information.
Command mode: Privileged EXEC
show ip nat translations
Displays configured translation entries list. For more information, see page
page
149.
Command mode: Privileged EXEC
show ip nat translations full
Displays configured translation entries list with counters for both directions.
For more information, see page page
Command mode: Privileged EXEC
The following command displays current NAT information:
show ip nat
Command mode: Privileged EXEC
Network address translation status: ENABLED.
Dynamic timeout expiry time is 300 seconds.
There are 5 entries in the NAT table, out of which
3 installed in hardware table
1 not installed because of missing egress
0 dynamically learned entries
5 statically configured entries
0 software only entries
There are 0 configured dynamic rules.
Following vlans are configured as inside: 1
Following vlans are configured as outside: 2
149.