Lenovo RackSwitch G8332 Command Reference Manual page 384

384
G8332 Command Reference for ENOS 8.4
Table 166.
Management Network Configuration Options
Command Syntax and Usage
no access management­network {snmp­ro|snmp­rw}
Clears the IPv4 SNMP read‐only or SNMP read/write access control list for
management purposes.
Command mode: Global configuration
[no] access management­network6 <mgmt network IPv6 address>
<IPv6 prefix length>
Adds or removes a defined network through which switch access is allowed
via Telnet, SNMP or the Enterprise NOS browser‐based interface. A range of
IPv6 addresses is produced when used with a prefix length. Specify an IPv6
address in hexadecimal format with colons.
Note: If you configure the management network without including the switch
interfaces, the configuration causes the Firewall Load Balancing health checks
to fail and creates a "Network Down" state on the network.
Command mode: Global configuration
[no] access management­network6 <mgmt network IPv6 address>
<IPv6 prefix length> {snmp­ro|snmp­rw}
Adds or removes a defined IPv6 network through which SNMP read‐only or
SNMP read/write switch access is allowed.
Command mode: Global configuration
no access management­network6 {snmp­ro|snmp­rw}
Clears the IPv6 SNMP read‐only or SNMP read/write access control list for
management purposes.
Command mode: Global configuration
show access management­network
Displays the current management network configuration.
Command mode: Privileged EXEC
clear access management­network
Removes all defined management networks.
Command mode: Privileged EXEC