Selecting A Software Image To Run; Uploading A Software Image From Your Switch - Lenovo RackSwitch G8332 Command Reference Manual

Selecting a Software Image to Run

1. In Global Configuration mode, enter:
2. Enter the name of the image you want the switch to use upon the next boot.

Uploading a Software Image from Your Switch

1. In Privileged EXEC mode, enter:
2. Select a port type to use for uploading the image.
3. Enter the name or the IP address of the SFTP, FTP or TFTP server:
4. Enter the name of the file into which the image will be uploaded on the SFTP, FTP
5. Enter your username and password for the server, if applicable.
6. The system then requests confirmation of what you have entered. To have the file
696
G8332 Command Reference for ENOS 8.4
You can select which software image (image1 or image2) you want to run in
switch memory for the next reboot.
RS G8332(config)# boot image {image1|image2}
The system informs you of which image set to be loaded at the next reboot:
Next boot will use switch software image1 instead of image2.
You can upload a software image from the switch to a SFTP, FTP or TFTP server.
RS G8332# copy {image1|image2|boot­image} {ftp|tftp|sftp}
Port type [DATA|MGT]:
Address or name of remote host:
or TFTP server:
Destination file name:
{
User name:
<username>
uploaded, enter Y.
image2 currently contains Software Version 6.6.0
that was downloaded at 0:23:39 Thu Jan 3, 2011.
Upload will transfer image2 (2788535 bytes) to file "image1"
on FTP/TFTP server 1.90.90.95.
Confirm upload operation (y/n) ? y
<IP address or hostname>
<filename>
|
}
<Enter>