Required And Optional Tools And Materials - SeeMeCNC Rostock MAX v2 Assembly Manual

1 – Required and Optional Tools And Materials
Before you begin assembly of your Rostock MAX v2, please make sure you've got everything
on the following list of tools and additional materials.
•
P1 & P2 sized Phillips screwdrivers
•
Standard flat head screwdriver
•
3/32" Allen (hex) wrench. A ball-end, T-handle version is a good choice for this and the other
sizes of Allen wrenches used
•
5/32" Allen (hex) wrench.
•
7/64" Allen (hex) wrench.
•
Needle nose pliers
•
Forceps – these will come in handy when routing the belts and reaching for small, hard to reach
parts. They can be purchased from Amazon for as little as $3.50 for a set of two.
•
Wire strippers
•
Wire cutters
•
5/16" open-ended wrench (Used primarily on the nuts that hold the Cheapskates together)
•
2 7/16" open end wrenches. (used to adjust Cheapskate Bearings)
•
11/16" open-ended wrench (used for hot-end mount)
•
PermaTex Ultra Copper High Temp RTV
Rostock MAX v2 Assembly Guide
7