Machine Won't Move; Belt Damage Or The Delta Arm Blues - SeeMeCNC Rostock MAX v2 Assembly Manual

Machine Won't Move!

You've sent G28 and the machine still won't move using the jog arrows. Take a look at the log
output. You may be seeing an error go by that looks like this:
What is most likely happening is that you haven't yet plugged the hot-end thermistor in. The
firmware is preventing the machine from moving because of this – it's a safety measure of sorts. A cold
thermistor will read ambient room temperature, but a failed one may not – it could read zero or some
very high number. The firmware is will prevent the Rostock MAX from operating if the thermistor
readings are below 3 degrees Celsius for the hot end and heated bed, or if the hot end temp is above
275 or the heated bed is above 140. (These are defaults and shouldn't be messed with unless you know
exactly what you're doing)

Belt Damage or The Delta Arm Blues!

So you're printing along and you start to notice things like this:
Rostock MAX v2 Assembly Guide
Extruder switched off. MINTEMP triggered!
Fig. B-3: Infill not meeting the perimeter.
280