SeeMeCNC Rostock MAX v2 Assembly Manual page 20

Rostock MAX v2 Assembly Guide
Rostock MAX v2 Electronics and Hardware Pack #4
(___) 1 each, RAMBo Electronic Control Board with screw terminals and
end stop wires.
(___) 1 each, USB Cable.
(___) 1 each, Onyx Heated Bed Kit.
(___) 1 each, LCD Smart Controller with SD card, LCD to RAMBo
Adapter Kit and 1 Soft Touch 5mm knob.
(___) 4 each, NEMA 17 Stepper Motors (4800cgm holding torque). Used
for three motion axes and extruder drive.
(___) 1 each, Rocker switch, including spade lug crimp terminals.
(___) 1 each, 25x25x10mm 12VDC fan. Used to cool the PEEK section
on the hot end.
20