SeeMeCNC Rostock MAX v2 Assembly Manual page 13

The cardboard box contains all the non-melamine components required to build the Rostock
MAX v2. Many are in individual baggies, some are in heat-sealed bag "packs". As you go through the
following Bill of Materials, please count and check off each item. This is important as you don't want
to be short a vital part during the build. It's better to find out before hand than being forced to stop the
assembly process due to a missing part. If you are missing any parts, please contact
support@seemecnc.com
the photographs may not necessarily match the quantity listed to the right. When it doubt, follow the
quantities listed in the text!
For those that aren't sure how to identify the various screw types, Bolt Depot has made available
some excellent references. I would recommend Fastener Basics
information/Printable-Tools/Fastener-Basics.pdf) and their Fastener Type Chart
(http://www.boltdepot.com/fastener-information/Type-Chart.aspx).
Rostock MAX v2 Assembly Guide
with the subject line of "Missing Parts!". Note that the quantities shown in
Hardware Package #1
Rubber foot pack. Contains 6 each of the following components:
(___) #10-32, 5/8" Nylon Pan Head Screws
(___) #10-32 Nylon Finish Nuts
(___) Injection molded legs (black)
(___) Soft rubber feet
(___) 9 each, #10-32, 3/4" Knurled Nylon Thumb Screws.
These are for the right & left base covers as well as the LCD panel.
(___) 4 each, #6-32, 1/2" Slotted Pan Head Screws (Nylon).
These are used to mount the 450W ATX power supply
(___) 31 each, #6-32, 1" Phillips Pan Head Screws. Used for general
assembly.
(http://www.boltdepot.com/fastener-
13