SeeMeCNC Rostock MAX v2 Assembly Manual page 82

Now you need to attach the thermistor signal leads. You'll find them in the box that the
RAMBo came in. It's a long, two wire (both white) cable with a connector fitted to one end.
Strip about 1/8" of the insulation of the bare ends of the thermistor wires and solder them on top
of the solder pads that are aligned with the two solder pads you soldered the thermistor to. One wire
per pad and take care to avoid solder bridges.
Rostock MAX v2 Assembly Guide
Fig. 5C-23: Thermistor signal wires.
Fig. 5C-24: Thermistor signal wires
installed.
82