SeeMeCNC Rostock MAX v2 Assembly Manual page 8

•
A small razor knife like an X-Acto knife. This will be handy for cleaning the flashing off the
injection molded parts.
•
1/2" wide roll of Kapton tape
•
Uninsulated crimp on connectors, sized for 22-18ga wire.
Radio Shack P/N 640-3036 is an excellent choice.
•
A digital caliper. These can be purchased from Harbor Freight tools for around $10.
•
A small squeeze clamp that can open at least 2"
•
Crimping tool (Jameco P/N 159266 is a good choice)
•
Battery powered screwdriver. If you ever needed an excuse to buy one of these, THIS IS IT.
•
Pencil.
•
40W Soldering Iron.
•
Blue thread locking compound (Loctite or Permatex Threadlocker Blue)
•
A small file.
•
Elmer's Glue Stick – must be marked "Disappearing Purple".
Rostock MAX v2 Assembly Guide
8