Dos Unit Type H D377; Accessory Check; Before You Begin - Ricoh D014 Service Manual

1.18.14 DOS UNIT TYPE H D377

Accessory Check

Check the accessories and their quantities against the table below.
Description
1. Data Overwrite Security SD Card
2. Operating Instructions CD-ROM
3. Comments Sheet (17 languages)

Before You Begin...

1. Make sure that the Data Overwrite Security unit SD card is the correct type for this
machine. The correct type for this machine is type "H".
2. Make sure that the following settings are not at the factory default settings:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the Data Overwrite Security unit
can be installed.
3. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you can
do the installation procedure.
4. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Available Settings
"Available Settings" is not displayed until Step 2 above is done.
If this setting is not selected tell the customer that this setting must be selected
before you can do the installation procedure.
SM
CÓPIA NÃO CONTROLADA
Qt'y
1
1
2
1-171
CÓPIA NÃO CONTROLADA
MFP Controller Options
D014/D015/D078/D079