Ricoh D014 Service Manual page 322

Common Procedures
To reinstall the hopper
1. Confirm that the transfer belt release lever [A] is up and locked before you reattach the
hopper.
2. Make sure the hopper rails are fully extended, then set the toner hopper [B] on the
rails,
3. Make sure the steel tabs of the hopper are inserted into the holes in the left rail [C] and
right rail [D].
4. Push up the release [E] and support leg [F].
Make sure that the support leg is up and locked before you push the toner
hopper into the machine.
5. Place your hands at the bottom of the toner hopper at
hopper against the face plate.
To avoid damaging the hopper, never press on the top of the toner hopper.
6. Check the right side and confirm that the hopper unit is flat against the faceplate.
If the toner hopper [B] is not flat against the face plate on the right side, pull it out
slightly and make sure that the transfer belt release lever is rotated up completely and
locked.
7. Fasten the toner hopper to the face plate (
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
x3).
3-16
CÓPIA NÃO CONTROLADA
and then push the
SM