Drum Motor Reinstallation
1.
Push the shaft into the machine and set the motor [A], so that it is straight.
2.
Attach the screws and tighten them only halfway. This leaves the motor shaft loose so
it can float slightly.
3.
Check the front of the machine and confirm that the shaft [B] is straight.
4.
At the front, set the faceplate set the shaft [A] as shown above.
5.
Fasten the faceplate with its screws (
6.
At the back, tighten the screws (
(
x1).
SM
CÓPIA NÃO CONTROLADA
x3).
x3) of the drum motor [B] and attach its connector
3-129
CÓPIA NÃO CONTROLADA
Motors
D014/D015/D078/D079