Service Call Conditions; Service Call Table; Troubleshooting - Ricoh D014 Service Manual

4. TROUBLESHOOTING

4.1 SERVICE CALL CONDITIONS

4.1.1 SERVICE CALL TABLE

There are 4 levels of service call conditions.
Level Definition
Fusing unit SCs are displayed on the
A operation panel. The machine is disabled,
and operator cannot reset the SC.
SCs that disable only the features that use
the defective item. These SCs are not shown
B to the operator under normal conditions. They
are displayed on the operation panel only
when the defective feature is selected.
SCs that are not shown on the operation
C
panel. They are internally logged.
Turning the operation switch (or main power
switch) off then on resets these SCs. These
D
SCs are displayed on the operation panel and
displayed again if the error reoccurs.
When a Level "D" SC code occurs
When a Level D SC occurs, a screen opens on the operation panel to tell the operator:
An error occurred
The job in progress will be erased
The machine will reboot automatically after approximately 30 seconds.
The operator can wait until the machine reboots automatically or touch "Reset" on the
screen to reset the machine immediately and go back to the copy screen.
SM
CÓPIA NÃO CONTROLADA
4-1
CÓPIA NÃO CONTROLADA
Service Call Conditions
Reset Procedure
Enter SP mode and do SP5810
to release the machine for
servicing.
Turn the main power switch off
and on.
Logging only
Turn the operation switch (or
main power switch) off and on,
or the machine reboots
automatically. (See below.)
D014/D015/D078/D079