Handling Dimms And Sd Cards; Dimms - Ricoh D014 Service Manual

MFP Controller Options
section)

1.18.5 HANDLING DIMMS AND SD CARDS

Always turn the machine off and disconnect the machine power cord before you
install a controller option.
To prevent damage to the controller box, always work carefully. Never put your
hand or a tool into the box when you remove the controller box or install an option.
To prevent damage to the circuits on the boards, always touch a metal surface to
remove static charge from your hands before you handle a board..

DIMMs

1. Hold the ROM DIMM as shown above. The edge connector [A] points toward the slot
and the notch [B] is in the top right corner.
2. Insert the edge connector [C] in the slot at a 30-degree angle from the surface of the
board. If the angle is too low, the upper contact could bend.
3. Carefully move the outer edge of the ROM DIMM up and down slightly until it goes into
the connector then carefully push it down unit it is level with the controller board.
If the upper contact is pushed in with force and bends, the connection will be
defective and the machine will not operate.
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
1-152
CÓPIA NÃO CONTROLADA
SM