Ricoh D014 Service Manual page 96

Installation Requirements
Europe/Asia
D014/D015/D078/D079 220 to 240V 50/60 Hz, more than 12A
Permissible voltage fluctuation: ±10%
Some electrical components are different, depending on the power supply used.
The following components are different, depending on the power supply.
1. Power supply cord
2. AC drive board
3. Fusing unit
4. Anti-condensation heaters
Paper trays
Paper transfer section
Scanner heater (option)
LCT (B473) heater (option)
LCIT (D350) heater (option)
Do not turn off the main power switch when the power LED is lit or flashing. To
prevent damage to the hard disk or memory, push the operation switch to turn the
power off, then do nothing until the power LED goes off, and then turn the main
power switch off.
There are two power switches on the machine:
Main Power Switch
This is located on the front left corner of the machine and has a plastic cover. This switch
must always be on unless a technician does work on the machine.
Operation Switch
This is located on the right side of the operation panel. This is the switch that the customer
uses to turn the machine on and off.
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
1-4
CÓPIA NÃO CONTROLADA
SM