Initializing Developer And Toner - Ricoh D014 Service Manual

Copier D014/D015/D078/D079

Initializing Developer and Toner

Before You Begin...
Follow this procedure in the correct order as described below.
Do not turn on the machine until you are instructed to do so.
To prevent damage to the drums during this procedure, make sure that the front
door is open before you switch on the machine.
If the machine is switched on during this procedure with the front door closed,
processing control executes. This causes the bare drums to rotate against the
counter blades before a light coat of toner has been applied to the surfaces of the
drums. This could damage the drum.
1. Open the front door [A].
You must open the front door.
Turning on the machine with the front door open prevents the machine from
performing the initial process control self-check.
If the front door is closed, the drums will start rotating with no toner in the
PCUs.
If the drums rotate with no toner in the PCUs, this can cause the cleaning
blades to catch on a dry drum and damage the drum surface.
2. With the front door open, turn on the main power switch.
3. Close the front door after "Open Cover" appears on the display.
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
1-26
CÓPIA NÃO CONTROLADA
SM