Ricoh D014 Service Manual page 409

2. Separate the two halves of the fusing unit [A].
3. Remove:
[B] Fusing belt separation pawl guide plate (
[C] MIN thickness plate (
[D] MAX thickness plate (
4. Insert MIN thickness plate [A] between the separation pawl [B] and fusing belt.
5. Turn screw [C] in 90 degree steps to adjust the gap to the thickness of the MIN
thickness plate inserted between the pawl and belt.
Turning the screw 90 degrees counter-clockwise
Turning the screw 90 degrees clockwise
SM
CÓPIA NÃO CONTROLADA
x2)
x1)
x1)
increases the gap.
3-103
CÓPIA NÃO CONTROLADA
Fusing Unit
reduces the gap.
D014/D015/D078/D079