Sc Code Descriptions - Ricoh D014 Service Manual

4.1.2 SC CODE DESCRIPTIONS

Before You Begin...
If a problem concerns a circuit board, disconnect and reconnect the connectors and
then test the machine. Often a loose or disconnected harness is the cause of the
problem. Always do this before you decide to replace the PCB.
If a motor lock error occurs, check the mechanical load before you decide to replace
the motor or sensors.
When a Level "A" or "B" SC occurs while in an SP mode, the machine cannot display
the SC number. If this occurs, check the SC number after leaving the SP mode.
The machine reboots automatically when the machine issues a Level "D" SC code.
This is done for Level "D" SC codes only.
Never turn off the main power switch when the power LED is lit or flashing. To
avoid damaging the hard disk or memory, press the operation switch to switch the
power off, wait for the power LED to go off, and then switch the main power switch
off.
The main power LED (
the main machine is communicating with a facsimile or the network server, or while the
machine is accessing the hard disk or memory for reading or writing data.
SM
CÓPIA NÃO CONTROLADA
) lights or flashes while the platen cover or ARDF is open, while
4-3
CÓPIA NÃO CONTROLADA
Service Call Conditions
D014/D015/D078/D079