Important Warning About Thermostats - Ricoh D014 Service Manual

Fusing Unit
6. Remove the MIN thickness plate.
7. Confirm that the MAX thickness plate [D] cannot slip between the separation pawl and
the fusing belt.
If the MAX thickness plate cannot slip between the separation pawl and fusing belt
, no further adjustment is necessary.
If the MAX thickness plate can slip between the separation pawl and fusing belt
repeat from Step 5 to reduce the gap.
8. Repeat this procedure from Step 4 for every separation pawl.
9. After the gaps have been adjusted for every pawl, reinstall the MIN and MAX thickness
plates.

3.7.5 IMPORTANT WARNING ABOUT THERMOSTATS

The old type of thermostat [A] has been replaced with a new type of thermostat [B]. The
new type has a rectangular cover with exposed edges.
Never attempt to reset a blown thermostat by manipulating the edges of the black
cover with a screw driver. Resetting a thermostat manually could cause a failure to
detect overheating in the fusing unit and cause a fire hazard.
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
3-104
CÓPIA NÃO CONTROLADA
,
SM