Counters
Always turn the machine off and disconnect the machine power cord before you
do this procedure.
1.
Remove the cover [A] (
2.
Remove the right upper cover [B] (
3.
Remove the three caps [C].
4.
If you are installing the key counter bracket, remove connector cover [D] (
5.
Attach stud [E].
6.
Put the keyholes [A] of the key card table [B] over the heads of the shoulder screws, as
shown above.
7.
Tighten the screws to attach the table (M4 x 14,
8.
Attach the key counter bracket or key card. (See below.)
If you are installing the key counter bracket ...
1.
Connect one end of the harness [A] to the key counter bracket [B] (
2.
Connect the other end to the 4-pin connector on the right side of the copier.
3.
Attach bracket support [C] to the side of the copier (
D014/D015/D078/D079
CÓPIA NÃO CONTROLADA
x 2).
x 2).
1-46
CÓPIA NÃO CONTROLADA
x 2).
x1).
x 2).
x 2).
SM