Adding Paper And Toner; Loading Paper Into The Paper Tray - Ricoh IM 2500 Series User Manual

9. Adding Paper and Toner

Loading Paper into the Paper Tray

The method of loading paper varies for each tray type.
• When replacing paper or removing jammed paper, make sure not to trap or injure your fingers.
Tray 1
Tray 2
Tray 3
Tray 4
Tray 3
• Before loading paper into a tray, check the paper size and type that can be loaded in the tray,
and confirm the paper size that is automatically detected.
page 198 "Recommended Paper Sizes and Types"
• When loading paper of a size that is not automatically detected, specify the paper size in [Tray/
Paper Settings] of [Settings].
page 192 "Specifying the Paper Size That Is Not Automatically Detected"
• To load thin paper, thick paper, or other special paper, specify the paper type or thickness in
[Tray/Paper Settings] of [Settings].
See "Tray/Paper Settings", User Guide (Full Version).
page 195 "Specifying Paper Type and Thickness Settings"
• Check the paper setting before printing. If the paper differs from the paper setting, a mismatch error
will occur when you print.
• Straighten curled or warped paper before loading.
• When loading paper on a tray which has a few sheets of paper, multiple sheets of paper may be
fed at once from the tray. Take out all sheets, fan the sheets, and then load them again.
Bypass Tray
Large Capacity Tray Tray 3 (LCT)
(LCT)
Large Capacity Tray
(LCT)
D0CHIA0402
183